Festo

Serial Interface VAEM Series　VAEM-L1-S-24-PT

Festo

Pneumatic Logic Controllers Series　CTEU-CC

The Festo bus node CTEU-CC handles the communication between the valve terminal and the higher Master of the Control & Communication Link (CC-Link R). The module provides basic diagnostics. 5 built-in LEDs for field display. Up to 8 bytes of input and 8 bytes of output are sent in the periodic process image. Dimensions (W x L x H): 40 mm x 91 mm x 50 mm Grid Dimensions: 40 mm Mounting Type (* auf Elektrik-Anschlussplatte, * auf Elektrik-Anschaltung), Product Weight 90 g, Protocol CC-Link

Festo

Time Delay Valve PZVT Series Minimum Operating Pressure: 2 bar Maximum Operating Pressure: 6 bar　PZVT-30-SEC

Parker

Time Delay Valve PRT Series　PRT-F10

All logic units must be installed on separate 2- or 3-port bases, sold separately.　The logic unit has input (green) and output (red) pressure indicators to indicate the status of the corresponding signal.　The unit comes with captive screws for all types of base mounting and a sealing o-ring is located on the bottom of each unit.
timer module

Parker

Pneumatic Logic Controller PLK Series　PLK-C10

All logic units require mounting on a separate 2 or 3 port base, available separately
Logic units have an input (green) and output (red) pressure indicator to show the state of the respective signal

Parker

Pneumatic Logic Controller PLJ Series　PLJ-C10

All logic units must be installed on separate 2- or 3-port bases, sold separately.　The logic unit has input (green) and output (red) pressure indicators to indicate the status of the corresponding signal.　The unit comes with captive screws for all types of base mounting and a sealing o-ring is located on the bottom of each unit.
YES Module

Crouzet

Crouzet 2 → 8bar 2 → 8s Pneumatic Timer, -5 → +50°C　81503720

Adjustable Time Delay Module. On application of a pilot signal the reservoir starts to fill via the low restrictor. After the set time delay the relay is operated and an output is given. The timer will not reset until the pilot signal is removed.

Crouzet

Crouzet 2 → 8bar 0.1 → 60s Pneumatic Timer, -5 → +50°C　81503725

Adjustable Time Delay Module. On application of a pilot signal the reservoir starts to fill via the low restrictor. After the set time delay the relay is operated and an output is given. The timer will not reset until the pilot signal is removed.

Crouzet

Crouzet 2 → 8bar NO Pneumatic Logic Controller, -5 → +50°C　81504035

Nominal size L: 32 x H: 25 x H: 28mm (except 619-5132 where H: 36mm). Sub Base Mounted. Operating pressure 2 to 8 bar 170 l/min flow rate @ 6 bar Operating temperature -5 to +50°C Orifice diameter 2.7mm Mechanical life >10 ;sup>7 ;/sup> operations

Crouzet

Crouzet 2 → 8bar OR Pneumatic Logic Controller, -5 → +50°C　81540015

Plug-in OR logic cell - Ø 4. One-touch connection OR logic cell for semi-rigid tube connection male / female / female (MFF): Ø 4 mm

Festo

Festo Pneumatic Logic Controller　CTEU-PN

CTEU Series Fieldbus Modules. Festo CTEU series fieldbus modules offer a simple, modular and cost-effective solution. With I-Port, Festo's new universal communication interface. With the I-Port numerous products can be connected to fieldbuses or directly to IO-Link.

Festo

Festo Pneumatic Logic Controller　CTEU-EP

CTEU Series Fieldbus Modules. Festo CTEU series fieldbus modules offer a simple, modular and cost-effective solution. With I-Port, Festo's new universal communication interface. With the I-Port numerous products can be connected to fieldbuses or directly to IO-Link.

Festo

Festo Serial Interface　CTEU-CO

CTEU Series Fieldbus Modules. Festo CTEU series fieldbus modules offer a simple, modular and cost-effective solution. With I-Port, Festo's new universal communication interface. With the I-Port numerous products can be connected to fieldbuses or directly to IO-Link.

Festo

Festo Serial Interface　CTEU-PB

CTEU Series Fieldbus Modules. Festo CTEU series fieldbus modules offer a simple, modular and cost-effective solution. With I-Port, Festo's new universal communication interface. With the I-Port numerous products can be connected to fieldbuses or directly to IO-Link.

Festo

Festo Serial Interface　CTEU-EC

CTEU Series Fieldbus Modules. Festo CTEU series fieldbus modules offer a simple, modular and cost-effective solution. With I-Port, Festo's new universal communication interface. With the I-Port numerous products can be connected to fieldbuses or directly to IO-Link.

Festo

Festo Serial Interface　VAEM-L1-S-8-PT

VAEM Manifold Electrical Interfaces. Multi-pin Plug Connection. 25 pin ; 136-6947 136-6947 , 44 pin ; 136-6948 136-6948 Standardised interface for direct connection to the fieldbus by mounting the bus node CTEU or to an IO-Link master via a cable Each pin on the multi-pin plug can actuate exactly one solenoid coil With 24 valve positions, 48 valve functions can be addressed The valves can be switched by means of positive or negative logic. I-Port interface/IO-Link. 8 valve ; 136-6931 136-6931 , 16 valve ; 136-6999 136-6999 , 24 valve ; 136-7000 136-7000 I-Port interface for bus nodes (CTEU) IO-Link mode for direct connection to a higher-order IO-Link master CANopen, DeviceNet, PROFIBUS, CC-LINK, EtherCAT protocols are supported in connection with the associated CTEU bus node The electrical supply/transmission of communication takes place via an M12 plug connector

Festo

Festo Serial Interface　VAEM-L1-S-M1-25

VAEM Manifold Electrical Interfaces. Multi-pin Plug Connection. 25 pin ; 136-6947 136-6947 , 44 pin ; 136-6948 136-6948 Standardised interface for direct connection to the fieldbus by mounting the bus node CTEU or to an IO-Link master via a cable Each pin on the multi-pin plug can actuate exactly one solenoid coil With 24 valve positions, 48 valve functions can be addressed The valves can be switched by means of positive or negative logic. I-Port interface/IO-Link. 8 valve ; 136-6931 136-6931 , 16 valve ; 136-6999 136-6999 , 24 valve ; 136-7000 136-7000 I-Port interface for bus nodes (CTEU) IO-Link mode for direct connection to a higher-order IO-Link master CANopen, DeviceNet, PROFIBUS, CC-LINK, EtherCAT protocols are supported in connection with the associated CTEU bus node The electrical supply/transmission of communication takes place via an M12 plug connector

Festo

Festo Serial Interface　VAEM-L1-S-M1-44

VAEM Manifold Electrical Interfaces. Multi-pin Plug Connection. 25 pin ; 136-6947 136-6947 , 44 pin ; 136-6948 136-6948 Standardised interface for direct connection to the fieldbus by mounting the bus node CTEU or to an IO-Link master via a cable Each pin on the multi-pin plug can actuate exactly one solenoid coil With 24 valve positions, 48 valve functions can be addressed The valves can be switched by means of positive or negative logic. I-Port interface/IO-Link. 8 valve ; 136-6931 136-6931 , 16 valve ; 136-6999 136-6999 , 24 valve ; 136-7000 136-7000 I-Port interface for bus nodes (CTEU) IO-Link mode for direct connection to a higher-order IO-Link master CANopen, DeviceNet, PROFIBUS, CC-LINK, EtherCAT protocols are supported in connection with the associated CTEU bus node The electrical supply/transmission of communication takes place via an M12 plug connector

Festo

Festo Serial Interface　VAEM-L1-S-16-PT

VAEM Manifold Electrical Interfaces. Multi-pin Plug Connection. 25 pin ; 136-6947 136-6947 , 44 pin ; 136-6948 136-6948 Standardised interface for direct connection to the fieldbus by mounting the bus node CTEU or to an IO-Link master via a cable Each pin on the multi-pin plug can actuate exactly one solenoid coil With 24 valve positions, 48 valve functions can be addressed The valves can be switched by means of positive or negative logic. I-Port interface/IO-Link. 8 valve ; 136-6931 136-6931 , 16 valve ; 136-6999 136-6999 , 24 valve ; 136-7000 136-7000 I-Port interface for bus nodes (CTEU) IO-Link mode for direct connection to a higher-order IO-Link master CANopen, DeviceNet, PROFIBUS, CC-LINK, EtherCAT protocols are supported in connection with the associated CTEU bus node The electrical supply/transmission of communication takes place via an M12 plug connector

Crouzet

Crouzet AND Connecting Base, -5 → +50°C　81531001

Rear Connecting Base for Logic Elements ; Relays (Rail Mounting). Rear connecting sub base to which modular logic elements are mounted using 2 screws. Fitted with clips for 8mm dia. mounting rails. 3 push in connections for 4mm semi rigid tubing

Crouzet

Crouzet 2 → 8bar YES Pneumatic Logic Controller, -5 → +50°C　81501025

Nominal size L: 32 x H: 25 x H: 28mm (except 619-5132 where H: 36mm). Sub Base Mounted. Operating pressure 2 to 8 bar 170 l/min flow rate @ 6 bar Operating temperature -5 to +50°C Orifice diameter 2.7mm Mechanical life >10 ;sup>7 ;/sup> operations

Crouzet

Crouzet 2 → 8bar YES Pneumatic Logic Controller, -5 → +50°C　81503025

Nominal size L: 32 x H: 25 x H: 28mm (except 619-5132 where H: 36mm). Sub Base Mounted. Operating pressure 2 to 8 bar 170 l/min flow rate @ 6 bar Operating temperature -5 to +50°C Orifice diameter 2.7mm Mechanical life >10 ;sup>7 ;/sup> operations

Crouzet

Crouzet 2 → 8bar NO Pneumatic Logic Controller, -5 → +50°C　81506025

Nominal size L: 32 x H: 25 x H: 28mm (except 619-5132 where H: 36mm). Sub Base Mounted. Operating pressure 2 to 8 bar 170 l/min flow rate @ 6 bar Operating temperature -5 to +50°C Orifice diameter 2.7mm Mechanical life >10 ;sup>7 ;/sup> operations

SMC Corporation

Serial Interface EX600 Series　EX600-DYPB

SMC Corporation

Serial Interface EX600 Series　EX600-SPR1A

Parker

Pneumatic Logic Controller PLL Series　PLL-C10

All logic units must be installed on separate 2- or 3-port bases, sold separately. The logic unit has input (green) and output (red) pressure indicators to indicate the status of the corresponding signal. The unit comes with captive screws for all types of base mounting and a sealing o-ring is located on the bottom of each unit.
AND Module

Festo

［Discontinued］Festo Serial Interface　VAEM-L1-S-24-PT

VAEM Manifold Electrical Interfaces. Multi-pin Plug Connection. 25 pin ; 136-6947 136-6947 , 44 pin ; 136-6948 136-6948 Standardised interface for direct connection to the fieldbus by mounting the bus node CTEU or to an IO-Link master via a cable Each pin on the multi-pin plug can actuate exactly one solenoid coil With 24 valve positions, 48 valve functions can be addressed The valves can be switched by means of positive or negative logic. I-Port interface/IO-Link. 8 valve ; 136-6931 136-6931 , 16 valve ; 136-6999 136-6999 , 24 valve ; 136-7000 136-7000 I-Port interface for bus nodes (CTEU) IO-Link mode for direct connection to a higher-order IO-Link master CANopen, DeviceNet, PROFIBUS, CC-LINK, EtherCAT protocols are supported in connection with the associated CTEU bus node The electrical supply/transmission of communication takes place via an M12 plug connector

SMC Corporation

［Discontinued］Serial Interface EX120 Series　EX120-SCS1