ข้อมูลจําเพาะ

• Processing inlet air volume (m^3/min): dew point -40°C/4.20, dew point -60°C/2.94
• Processing outlet air volume (m^3/min): dew point -40°C/3.60, dew point -60°C/2.10
• Processing and regeneration air volume (m^3/min): dew point -40°C/0.60, dew point -60°C/0.84
• Weight: 110 kg
• Connection Diameter (Air Inlet/Outlet): Rc1/2
• Connection Diameter (Regenerative Air Outlet): Rc1
• Fluid Used: Compressed Air
• Working (gauge) pressure: 0.39~1.0 MPa
• Ambient temperature: 2~40°C
• Input air temperature humidity: 5~50°C saturation or less (no drain water)
• Power: Single phase 100~230 V 50/60Hz
• Dimensions: 335 x 589 x 1475 mm
• Accessory Inlet Filter Element: MSF700D/EMS700 H
• Attached Outlet Filter Element: LSF700/ELS7000
• Dew point display (digital display): 5°C unit
• Energy-saving dew point sensor: Yes
• Energy saving dew point setting function: -40°C~0°C (10°C unit)
• *The amount of processed air is converted to the suction condition of the air compressor. (Atmospheric pressure, 32 degrees C, 75%)
• *The treatment conditions were as follows: inlet air temperature humidity: 35°C/saturation or less (no water droplets), inlet air pressure (gauge pressure): 0.7 MPa, ambient temperature: 32°C.
• *If the unit is operated continuously for 24 hours, it is recommended to install a refrigeration dryer in the front stage or use air treated by a refrigeration dryer.
• *If the machine is operated continuously for 24 hours, install a backup machine just in case.
• *We can make other specifications, so please ask us separately.
• *The sensor may deteriorate if it is used or stored in the following atmosphere. (Organic gases, acetic acid, ammonia chloride, ethyl acetate, xylene, butanol, dichloroethane)
• *The dew point of -60°C is a special specification because it is a dedicated orifice. In the case of the Super Pack with a dew point of −60°C specification, the dew point display range is −50~0°C (5°C unit).
• *Be sure to check the piping system design standards in the product specifications before installation.
• *When the inlet air temperature is 7°C or more higher than the ambient temperature, be sure to install an aftercooler (optional) or a refrigeration air dryer.
• *Be sure to install an air tank in front of the air dryer.
•