사양

• Received Signal: 0~250 mV DC
• alarm setting
• Densitometer Mode Type I (optional by user)
• Initial value
• 18% lower limit, 26% upper limit
• Buzzer, Lamp, Relay With Output, Output Hold
• Display range: 0.0~25.0%O2
• Measurement value display: Digital display with 3-digit yellow-green LED
• Display range (resolution): 0.0~25.0 (0.1)%O2
• Accuracy rating: ±0.3%O2±1digit
• DC voltage output
• Used as a power supply for MG2100
• Output voltage: 5 V±0.5 V DC
• Connected Model: 1 MG2100 or MG1000 Series
• Alarm function: Measured value alarm ...
• Alarm setting code: Densitometer mode *1
• *1 Alarm setting "A" is set to the initial value at the time of shipment, and alarm setting "B" is set to the state of alarm setting "0" for unspecified alarm value and alarm output operation.
• Lower warning value: within 0~26% Optional *2
• Upper warning value: within 0~26% Optional *2
• *2 The lower alarm value cannot be set to a value larger than the upper alarm value or cannot be specified. When alarm release alarm is held, it is released by front reset key.
• Relay output ON/OFF: Optional setting
• Buzzer Blow On/Off: Optional
• Lamp ON/OFF: Optional setting
• With/without output holding: Optional setting
• Power failure warning: When the power supply to the tester is OFF or when the fuse is broken, relay output is ON.
• Alarm relay output: number of output circuits (2), output capacity (Resistive Load 110 V AC 0.2 A, 24 V DC 1 A/Inductive Load 110 V AC 0.1 A, 24 V DC 0.5 A)
• Warm-up time: 5 minutes
• Note)Alarm signal OFF during warm-up
• Operating Temperature Range: 0~40°C
• Operating humidity range: 80%rh or less
• Power: 100 VAC ±10% 50/60Hz
• Power Consumption
• Approx. 5VA for the main body only (when DC voltage output is unloaded)
• Approx. 8.5VA when used in combination with MG2100 series
• Weight: about 500 g
• Mounting method: wall or switchbox mounting
• ISO 14001 Certified JQA-EM2414
• ISO 9001 Certification JQA-0656
•