Spec

• DC drive: diaphragm system
• A diaphragm is used for the seal part of the compression chamber.
• With Brush: DC Motor
• Equipped with a brushed motor for easy control.
• Liquid: A device for sucking and discharging liquid into the compression chamber.
• Twin head type: One motor moves two compressors.
• Rated voltage: 24 VDC
• Flow rate * 1:800 mL/min
• Working pressure range: 0~100 kPa{0~1kgf/cm2}
• Maximum pressure * 2:300 kPa{3kgf/cm2}
• Maximum current: 600 mA
• Rated Time: Continuous
• Useful Life (MTTF): 600 hours
• Self Absorption Force * 1:40 kPa{300mmHg}
• Inlet Size: φ5.4 mm (Outer Diameter)
• Discharge Port Size: φ5.4 mm (Outer Diameter)
• Coil insulation class: Class E equivalent
• Mounting Dimensions: 74.5 (L) x 41 (W) mm
• Body Weight: 350 g
• *1) When the liquid becomes low, the check valve hardens and the flow rate and self-suction force decrease.
• *2) Restarting from the closed state is not possible. Do not use at maximum pressure.
• The above performance is the value when piping both heads in parallel. Cannot be used in series piping.
• Can also be used as a gas pump or vacuum pump.
• Terms of Use
• Operating Ambient Temperature: 5~40°C
• Operating ambient humidity: 30~85%
• Operating fluid temperature: 5~50°C
• [Wetted Part Material and Applicable Fluid]
• Materials Used: Cylinder Head/PA Polyamide, Head Cover/PA Polyamide, Diaphragm/PTFE Fluororesin, Check Valve/FKM Fluororubber, O-Ring/FKM Fluororubber
• Appropriate chemical resistance * 1: Ethanol, mineral oil, ethylene glycol, sodium carbonate
• Examples of chemical resistance failure: chlorosulfonic acid, formalin, glacial acetic acid, methyl ethyl ketone
• *1) Appropriate chemical resistance is for reference only. Please check under operating conditions when using.
•