特徴

• This is a very simple shaped kinematic mirror holder made of two boards.
• Since the structure is simple, it is excellent for aging and temperature change.
• Can be used as a mirror holder for laser resonators and interferometers.
• There are two types, MHG-HS which is a Takayasu type mirror holder and MHG-MP which is a mass production type mirror holder.
• The high stability type (MHG-HS) has a large screw knob that allows adjustment of the fulcrum as well as the two points of action, and also the vertical displacement of the mirror.
• Other than the MHG-HS type, the adjustment screw has a set bolt type locking mechanism.
• The mirror side is held in place at three points so that the stress generated when the mirror is held in place can be adjusted.
• Since there is no restriction on the effective diameter due to the screw ring, a large effective diameter can be obtained with reflected or transmitted light.
• Can be attached to a post stand (PST: sold separately) or a rod (RO: sold separately) on the tip M6.
• The production type (MHG-MP) can be fixed directly to the plate or stage with M4 screws.
• * The center of rotation of the mass-produced type (MHG-MP) is located outside the mirror (the fulcrum of the holder).
• * Use the rod mounting plate (MHG -** BPRO) when fixing the Takayasu standard (MHG-HS) to a flat surface.
• * The optical axis is 10 mm higher when the rod mounting plate (MHG -** BPRO) is used.
• * Since the mirror frame is attached to the rear side of the mirror, the position of the reflecting surface changes when the mirror thickness changes.