ข้อมูลจําเพาะ

• Voltage (AC): 100 V
• Capacity (at room temperature): 100 W±25%
• Heater Dimensions (mm): 10 x 20
• Watt density (at room temperature): 50 W/cm2
• Maximum Operating Temperature: 600°C
• High wattage density and fast temperature rise speed, so please control the temperature.
• The capacity is at room temperature and will change with temperature rise. When using, refer to the resistance change characteristics.
• Precautions for Use
• When the product is used in contact with an object to be heated, be sure to use buffer insulation (ceramic fiber blanket, etc.) to absorb warping of the object due to heat. (Refer to the included Owner's Manual.)
• Temperature rises and falls in a short time. It is recommended to use the heater with a gentle temperature rise and temperature fall speed so as not to burden the heater, peripheral parts and insulation. (The ideal temperature rise rate is 100°C/min and the ideal temperature fall rate is 200°C/min or less.)
• When heating from a low temperature atmosphere below room temperature, the capacity density increases due to a decrease in the heater resistance value. If the heater is applied at the rated voltage, the heater may break. Use a voltage regulator to gradually increase the voltage from low to high.
• The thermal shock resistance of alumina substrates is approximately 200°C. Be careful not to cause a sudden and large temperature difference on the heater surface.
• Use AC power.
• For temperature control, the SCR-SHQ-A2 temperature controller is recommended. This device can also be tilted.
• The heat resistant temperature of polyimide tube is 300°C or less. When using at high temperatures of 300°C or higher, remove the polyimide tube and replace with an optional insulator.
•