คุณลักษณะ

• Short shank ball for high-precision shrink fit holder.
• High-hardness mold material processing of 40HRC or higher achieves machining efficiency, longer life and higher quality machining surface than before.
• The HARDMAX coat has been used to enhance film hardness while maintaining high levels of heat resistance, toughness, and lubrication.
• Stable machining is possible for both water-soluble and oily cutting oil, oil mist and air blow.
• The rake angle on the outer periphery side of the ball was set to a weak negative to ensure sharpness and prevent good processing surface and toppling.
• Compatible Work Materials: Pre-Hardened Steel, Quenched Steel (~55HRC) (~60HRC) (~70HRC), Carbon Steel, Alloy Steel, Cast Iron, Copper, Titanium Alloy, Super Heat-Resistant Alloy
• Shank Taper Angle is a guide
• If interference with the work piece is necessary, be sure to take actual measurements.
• Be careful of contact between the shank and the work piece.