기능

• Holder for fixing minute lens of φ3mm or less.
• The lens and other elements can be fixed to the tip of the elongated arm so that various devices can be placed near the front and back of the lens.
• It can be used for collimating lenses of fiber and semiconductor lasers.
• Since the arm holds the lens with a light spring force, there is no need to worry about the lens falling off during the work.
• The device can be easily and securely attached by removing the MLH-SF from the adapter and pinching the device in the horizontal plane from the left and right sides with an arm.
• The MLH-10ADP-2 is mounted on a □ 40 mm XYZ stage (TSD-405 L) for precise positioning of the device.
• The MLH-10ADP-2 is attached to a fiber holder (FOP) for position and tilt adjustment.
• The MLH-SF has M6 screw holes in the buttocks so you can connect the rods. However, the rod (RO) does not attach to the MLH-10ADP.
• The arm has no steps, so it can be fixed even with a lens with a thickness of 2 mm or more.
• Selfoc (R) Lens is a registered trademark of Nippon Sheet Glass Corporation.
• * Because the tip of the arm has a V-shaped notch, the square-shaped element may tilt and attach.
• * Either fix the device in a position away from the V-shaped groove, or fix the flat upper arm surface in close contact with the device.
• * The MLH-10ADP-2 is not attached to the cross movement holder (TAT) other than the FOP.
• * When installing the MLH-10ADP-2 to the FOP, the adapter of the FOP must be removed.