LOBTEX CO., LTD.

68-1791-73　Nutter 2 (for M4)　HNC24M

Fitur

Convenient kit for easy use of blind nuts!
By using "Chokka-Nutter 2," anyone can easily install shrimp nuts without troublesome setting and operation.
Shrimp nut is a blind fastener which has both advantages of nut and rivet.
Can be easily attached from one side to thin materials that are difficult to tap or plastic plates that cannot be welded.

Caulking Plate Thickness (mm): 1.0~2.0
Pilot Hole Diameter (mm): 6.1
Applicable Screw: M4 x 0.7
Nut Outer Diameter (mm): 6.8
Total length (mm): 11.3
Flange thickness (mm): 0.5
Pack Quantity (Pieces): 6
specifications: small flange
Material: Aluminum (A5056)
Torque Strength (N · m): 4.9
Thread Tamping Strength (kN): 4.0
For use, a 7 mm opposite-side box wrench and a 3 mm opposite-side hex wrench are required.
Before using the product, please read all of the "Instruction Manual" attached to the product carefully, and use the product properly after fully understanding it.
Do not over-tighten. It may damage the thread part of the shrimp nut.
Use within the proper crimping plate thickness of shrimp nut. If the proper crimping plate thickness is exceeded, the performance will not be satisfactory.
Specifications are subject to change without notice.
Dimensions are nominal values, so there may be slight variations. << Set Contents >>
Nutter Body for M4 x 1
Mandrel x 1
Hex Nut x 2
Aluminum Shrimp Nut (NAK4M) x 6

Perintah No.	68-1791-73
Model No.	HNC24M
Kode JAN	4963202002752
Harga standar	JPY: 2,470 USD: 15.37 Excange rate 1USD= 160.72JPY Valid price in Japan
Kuantitas	1set
Saham di Jepang
Saham Pemasok

Perintah No.	Nama	Model No.	Kuantitas	Harga standar	Harga valid di Jepang
68-1791-73	Nutter 2 (for M4)　HNC24M	HNC24M	1set	JPY: 2,470	USD: 15.37
68-1791-74	Nutter 2 (for M5)　HNC25M	HNC25M	1set	JPY: 2,470	USD: 15.37
68-1791-75	Nutter 2 (for M6)　HNC26M	HNC26M	1set	JPY: 2,470	USD: 15.37