Fitur

• This is an original product that is compatible with the installation part of the micrometer head used for the manual stage of the company.
• Since the operation section can be consolidated in one direction, it is effective for work efficiency because it is easy to operate in places with built-in equipment or restrictions.
• Compatible with product installation instructions using the micrometer head of the company (MDC-6.5⇔SHT1-6.5, MDC-13⇔SHS2-13).
• After loosening the screws of the folded micrometer head, it is possible to rotate it and fix it at any position.
• Depending on the situation, it can be used in the most convenient position.
• There are R type and flat type tip shape.
• Since the principle of leverage is applied, the feed amount relative to the scale of the micrometer head is 1:1 near the center, but the lateral deviation of the lever part occurs at the periphery, so use the scale as a guide.
• * Depending on the type and direction of the stage on which the folding micrometer head is installed, the movement range may be narrowed or interference with the installation parts may occur.
• * It is recommended to check in advance when replacing with a micrometer head.
• * MDC-6.5/6.5R uses dedicated nuts.
• * Nut turning MNS-12.5-14.5 cannot be used.
• * If you install or tighten the MDC-13/13R by yourself, a special tool (MNS -12.5-14.5) is provided.