Fitur

• Since compressed air is used from the compressor in the factory, a vacuum pump is not required.
• Holemaking can be performed by using sub-plates.
• With a key groove on the bottom, you can accurately show the degree of parallelism and straight angle.
• Ideal for processing thin non-magnetic materials (aluminum, stain plastic, etc.) in machining centers and polishing machines.
• Since the holding circuit is installed in the standard tower, the safety level of the unstable time of air is enhanced.
• When the switch is turned off, air is back-jetted through the suction hole to prevent contamination of relics, so little maintenance is required.
• Since there is a screw hole on the bottom, it can be used on the vice by attaching a pincer plate according to the opening width of the vice.
• Ideal for thin material processing in machining, milling and polishing machine processing.
• Can also be used for machining with cutting oil.
• With stopper plate for positioning on the side of the main body (left side and back side) and preventing the workpiece from shifting.
• For processing thin non-magnetic materials (aluminum, stain plastic, etc.) in machining/milling/polishing machines.