[AS ONE Corporation]Water Level Indicator & Leakage
Filters
-
Water Level Holding Controller WLC-SA2
The water level sensor is suction type, so it can be installed at any depth inside the water tank. (Cable length: approx. 300 mm) The water level sensor can be replaced with a footswitch (sold separately), and forced fluid feed using the footswitch is also possible.
It has a wall mounting hole (Dharma hole) on the back and can be fixed with two M4 screws.1 products found
JPY: 108,000
USD: 676.99
-
Constant Level HCL-10-R
When the water level falls below the set level, the water is automatically fed to maintain a constant water level.
Connect to the thermostatic unit.1 products found
JPY: 68,100
USD: 426.88
-
［Discontinued］Water Level Sensor for Waste Water Tank (For Resin Tank) WLS
This sensor is attached on resin or glass（non-metal）container. It detects water level contactlessly and informs it by LED.
Adopts capacitance system that can detects water level even in opaque container.1 products found
JPY: 45,000
USD: 282.08
-
［Discontinued］HFS-15 Float Switch HFS-15
When water level falls below setup, power supply will beturned OFF automatically.
Please use it connecting to the thermostat.1 products found
JPY: 27,500
USD: 172.38
-
［Discontinued］Water Level Holding Controller WLC-SA
The large ring compresses the tube to reduce load and assure long life.
Only the tube touches the liquid due to adoption of ring pump.1 products found
JPY: 49,000
USD: 307.15
