Features

• A wireless charger that magnetically secures the MagSafe iPhone series for fast charging at 7.5 watts, while also charging the AirPods series for wireless charging.
• * The charging output of this product is 7.5 W for the magnet part and 5 W for the pedestal part.
• It does not support MagSafe 15 W charging.
• Since the coil position is matched by the magnet, it can be charged efficiently.
• Since the Lightning connector is not used, it can be charged while using earphones, and also prevents short circuit accidents caused by wet connectors.
• * This product is not waterproof.
• Magnet attaches to the back of iPhone, so you can easily operate your smartphone while charging.
• Charging is possible even when the smartphone is placed vertically or horizontally.
• Anti-slip pads are placed on the base to prevent scratches or slipping off the AirPods.
• Equipped with functions such as foreign matter detection and temperature rise protection, it can be used safely.
• It has an operation confirmation LED to check the charging status.
• A weight is built into the base, so you can place your smartphone stably.
• It is also possible to charge while the MagSafe compatible case is attached to the magnet part and the wireless charging compatible case is attached to the pedestal part.
• * Only cases with a thickness of 3 mm or less.
• Even if the case is 3mm or smaller, it may not be able to be charged depending on the specifications and conditions.
• It is the same color as the main unit and uses an integrated cable of about 150 cm in length that can be loosely connected.
• This product uses magnets.
• Keep magnetic cards (credit cards, cash cards, etc.) away.
• USB output adaptor (AC charger, etc.) is not included with this printer.
• To use this product, prepare a USB Power Delivery20W or higher USB output adapter separately.
• * For models that support charging, refer to the table below.
• ※USB Type-C and USB-C are trademarks of USB Implementers Forum