Spec

• material: Vernier: Stainless Steel, ・ Base: Cast Iron, ・ Scriber: carbide Tip
• Maximum Measurement Length: 600 mm
• Minimum Reading: 0.01 mm
• instrument difference : ± 0.05
• Slider fine motion Feed upper and lower Amount: 10 mm
• power supply: SR 44 (silver oxide battery) test 1 piece included
• Accessory: Dial Indicator (our company Product Number : TI -8038) Holder Arm for Mounting Dial Indicator, Scriber
• Stable measurement using dial indicators is possible.
• Ideal for Scribing Work
• Body Total length: 837 mm
• Body A: 837 mm
• Body B: 178 mm
• Body C: 54 mm
• Body D: 114 mm
• Body E: 66 mm
• Body F: 82 mm
• Body G: 35 mm
• Body H: 15 mm
• Body J: 140 mm
• *When using dial indicators, use either the supplied dial indicator mounting holder arm or the dedicated VHS test indicator holder (VHS-T). However, the measuring point comes out earlier than the scriber, so it may not reach the instrument difference described.
•  
• Document Content: calibration certificate Traceability Chart
• Calibration points are the calibration points specified by the manufacturer. If you specify calibration points separately, you need to make a separate estimate.
•