Spec

• Fluid to be measured: gas, liquid (not corroding the wetted part material)
• Mounting Type: Directly Connected (The standard is wire outlet: bottom pressure inlet: bottom.) Pressure Inlet: Lower (Standard) (Internal Terminal Connection)
• Pressure Connection Fittings: Rc1/4 (Standard)
• Connection Part Material: Diaphragm: SUS630 (17-4 PH) Joint: SUS316
• Pressure range (MPA): 0~3.5
• Output accuracy: ±0.5%F.S. at23°C
• Display accuracy: ±(0.25%F.S. +1digit), ±(0.5%F.S. +1digit) or ±(1.0%F.S. +1digit)at 23°C (same as output accuracy)
• Maximum allowable pressure: 2 times the pressure range, 1.5 times the 35, 50 MPa range, 1.2 times the 70 MPa range and above (Wetted Part Material: SUS316 L: 1.5 times for 2 MPa range or less, 1.2 times for 3.5 MPa range or more)
• Case Protection Structure: Case Material: Aluminum Die Cast/Protection Grade: IP65
• Location: Can be installed outdoors (avoid direct sunlight)
• Weight: Direct Connection Type: Approx. 450 g, Panel Mounting Type: Approx. 550 g, Terminal Box Type: Approx. 630 g
• Power source: 24 V DC±10%
• Output: 4~20 mA DC(2 Wire, Output Range: 3.2~20.8 mA DC) Responsiveness: 30 ms (filter setting: 0) Resolution: 0.1%F.S. Load resistance: 500 Ω max.
• Accuracy Guarantee Range: ±1.0%F.S. (0.5 MPa or More), ±2.0%F.S. (0.3 MPa or Less) at Operating Temperature Range (-20~70°C)
• Insulation resistance: 50 V DC 100 MΩ or more
• Wire Outlet: Direct Connection Type, Panel Mounting: SKINTOP R MS-SC13.5/Terminal Box Type: Cable Grand FBA21-13 G1/2
• Operating temperature and humidity range: -20~70°C, 10~85%RH (no freezing or condensation)
• Storage temperature and humidity range: -20~75°C, 10~85%RH (no freezing or condensation)
• Vibration resistance: 10~150 Hz, dual amplitude 0.7 mm (less than 60 Hz) Acceleration: 50 m/s2 (60 Hz or more) Vibration direction: 3 directions xyz, 2.5 hours each
• Impact resistance: Impact acceleration: 100 m/s2 Impact direction: xyz forward and reverse (6 directions), 3 times each
• Power adjustment range: zero point: -10~110%F.S. of full span (for pressure range) Span point: -10~110%F.S. of the full span (relative to the pressure range)
• Numerical display: 6 digits LCD(Character height 10 mm, with LED backlight) Pressure/Linear display: LCD max. 4 digits, display cycle 500 ms
• Unit Display: LCD Bar Display (LED Backlit) Pressure Unit: kPa, MPa, Linear Unit: Optional
• configuring: internal key switches (MODE,, ▼ Linear Display/Output Hold Function: Displays the maximum and minimum measured values. Filter Function: Selects the moving average count (1, 2, 4, 8, 16). Loop Check Function: Optional Output (4~20 mA DC) Zero Adjust Function: Adjusts the pressure sensor zero point.
• Others: Set and hold values are semi-permanently stored in EEPROM (non-volatile memory).
•