기능

• High output 670 W heater and large air volume increase work efficiency
• Easy and safe removal with additional vacuum pickup function
• Simple profiles can be created using the preset linkage function
• Further evolution of high-power, high-air volume SMD reworkstations
• High output and large air volume for "quick removal"
• Improvement of work efficiency
• By increasing the volume and output of hot air, it is possible to achieve the same working effect in about 1/3 of the time compared to conventional products, and to reduce the thermal effect on the substrate and parts.
• *Set both the set temperature and air volume to the maximum, and verify the time required for the soldered connector on the ceramic substrate to heat up to 200°C.
• Evolution of FR-810B
• The FR-810B retains the high power and large air volume performance of the conventional FR-810, but adds 2 new functions: a vacuum pickup and a pickup indicator.
• Risks associated with SMD rework include damaging the circuit board with tweezers when removing parts from the circuit board, or lifting parts when solder has not melted sufficiently to peel off lands. 2 new features of FR-810B enable removal of parts without damaging the substrate lands
• Improved temperature characteristics with new nozzle
• By providing a hole at the top of the nozzle, convection of hot air is generated in the nozzle, and the outside and center of the nozzle can be heated uniformly, improving workability. (BGA nozzle only)
• Equipped with vacuum pickup function
• It is equipped with a vacuum pickup so that parts can be adsorbed and lifted. It is adsorbed beforehand, and when the solder melts, the part is lifted by the spring mechanism. Prevents mistakes such as forcibly pulling up parts and peeling off lands.
• You can see the pickup timing at a glance! Pickup indicator
• By setting the vacuum pickup function in advance, when the solder melts and the parts are picked up automatically, the indicator rises, and the moment of pickup is visible.
• Even if the parts are hidden by the nozzle and the moment when the solder melts cannot be seen, it is possible to know that the removal has been completed, making the pickup work easy and safe.
• Easy Removal Nozzle & Maintenance
• Nozzle can be quickly replaced to suit a wide variety of parts.
• Heater replacement is also easy and reliable.
• Conventional nozzles can also be used.
• Conventional nozzles can be used by fitting the screw tightening part to the convex part.
• Timer function keeps working time constant
• Prevents overheating of parts and facilitates repetitive work.
• *When "---" is input, continuous operation is performed.
• Simple profile creation with preset linkage function
• You can create a simple temperature profile by connecting the timer function and registered preset modes. (Up to 5 steps can be made) Work time is constant, prevention of overheating to parts and repetitive work are easy, and advanced removal work is also supported. It greatly improves workability.
• Auto Sleep/Auto Shutoff function
• Designed for safety and energy conservation. When the trowel part is placed on the trowel holder, the auto sleep function works, starts cooling and automatically shifts to the standby state. If you do not perform any operation for 30 minutes, the auto shut-off function will activate and the FOMA terminal will enter standby mode. Passwords also restrict access to settings for easier management.
• Optional low-cost rework systems can be built
• By using grip fixtures, board holders and bottom heaters, a low-cost rework system can be constructed and further work standardization is possible.
• Lead-free recommended: This product is also recommended for work using lead-free solder.
• RoHS Compliant (as of July 2024): This product complies with the regulation values of 10 substances prohibited by the European RoHS Directive.