기능

• A stopper that absorbs vibration and prevents a cabinet from tipping over.
• 2 pieces.
• The special material polyurethane foam absorbs shaking firmly.
• You can just put it on. A safe and secure design that does not scratch walls.
• Can be mounted on either the top or side. (Please attach it to the top as much as possible)
• Can be used even if the back is open like a TV stand.
• 1. Move the object about 20~30 cm away from the wall and peel off the smaller strip of paper.
• 2. Attach the peeled surface of the peeling paper to the object and press it hard 3~4 times.
• 3. Peel off the peeling paper on the wall side, attach it in the same way, and press hard against the wall 3~4 times.
• 4. As long as there is no damage to the cloth adhesive material or sponge and no dirt on the adhesive surface, it can be used repeatedly.
• 1. Slowly pull the object forward until you can place your hand between the object and the wall, put your finger between the material and the wall, and then remove the material attached to the object.
• 2. If the material is strongly stuck to the object or the wall due to long-term mounting, etc., do not try to remove it forcibly. Remove it little by little using a commercially available tape remover or cut the sponge with a cutter, etc., and then use the tape remover to remove it without damaging the wall.
• < Wall materials that cannot be mounted > • Cement mortar, hemlock plaster (sand or powder peels off from the surface), soft wallpaper (soft and easy to peel off when pressed with fingers), cork wallpaper (cork on the surface), paper wallpaper (wallpaper made of Japanese paper or paper cloth), fusuma, shoji, etc.