69-9205-93 Swaging Dies SD40
Fitur
- Die for manual hydraulic flare swaging tool.
- Deburr the cut end of the pipe before machining.
- If deburring is insufficient, correct machining may not be possible.
- Remove burrs completely.
- Tighten the gauge securely using the supplied shaft.
- If the tightening is weak, a good machined surface may not be obtained.
- Set the gauge securely in the yoke groove of the main body.
- Otherwise, the gauge may come off during processing.
Spec
- Operating range (for copper pipe): 1/2"
| Perintah No. | 69-9205-93 | |
|---|---|---|
| Model No. | SD40 | |
| Kode JAN | 4963202036047 | |
| Harga standar |
JPY: 3,440
USD: 21.56
Excange rate 1USD= 159.53JPY
Valid price in Japan |
|
| Kuantitas | 1pack | |
| Saham di Jepang |
|
|
| Saham Pemasok |
|
|