Fitur

• Ideal for compact piping.
• You can also flush it.
• The cut mark useful for cutting tubes is displayed at intervals of about 500 mm.
• Use of insert ring is recommended. (If you need to ensure the drawing strength of JIS standard, use insert ring.). (JISB 8381-1))
• Make sure that the tube is not subjected to loads such as tension, torsion or extreme bending. This may cause the tube to collapse, burst, or fall out.
• The breaking pressure of the tube decreases with the increase of temperature, so please understand the working pressure well and check the safety factor with sufficient margin.
• Use the tube with a minimum bend radius.
• When attaching a tube to a one-touch joint, check whether the cut area of the tube is cut at a right angle, whether the outer diameter of the tube is scratched, and whether the tube is elliptical.