EAGLE (Konno Corporation)

Vertical change for lightweight Clamp E-350 kg (2-16) and others

EAGLE (Konno Corporation)

Horizontal change Clamp for AMS-500 kg (3-20) and others

EAGLE (Konno Corporation)

Horizontal change Clamp VAF-500 kg (3-35) and others

EAGLE (Konno Corporation)

Screw type all directions Clamp SBB-500 kg (1-25) and others

EAGLE (Konno Corporation)

Screw type all directions Clamp SBN-1t (1-30) and others

EAGLE (Konno Corporation)

Hanging clamp (EST-250 for concrete products)　EST-250

By replacing the opening adjustment pin, 8 levels of opening adjustment are possible.
Urethane rubber is used, so it can be lifted and transported without damaging the suspended load.

EAGLE (Konno Corporation)

U-shaped groove lid Clamp for UGH-200　UGH-200

Two persons can remove and install the groove pig.
Hand hanging and machine hanging type.

EAGLE (Konno Corporation)

Steel block change pelican Hook JDH-1t and others

EAGLE (Konno Corporation)

EH-1t and others

EAGLE (Konno Corporation)

Low floor, Clean room Lever Rotation Hydraulic Jack capacity of 10 t and others

EAGLE (Konno Corporation)

Lever G-25-60 and others

EAGLE (Konno Corporation)

Power wedge capacity of 15 t and others

EAGLE (Konno Corporation)

Single-acting type Separation Type Ultra Low floor cylinder Jack 20t and others

EAGLE (Konno Corporation)

Smart Dolly and others

EAGLE (Konno Corporation)

Smart Dolly Low-Floor type and others

EAGLE (Konno Corporation)

Urethane Wheels for Smart Dolly　SDW-46

Urethane wheels for low-floor smart dollies.
As replacement wheels for SDL-20F and SDL-30F.

EAGLE (Konno Corporation)

Cylinder Jack (Ultra Low Floor/2-stage Type) 5 ton 84 -154 mm and others

EAGLE (Konno Corporation)

High pressure hose (2 m) [For EA993KG-5/-10]　EA993KG-11

EAGLE (Konno Corporation)

Hydraulic pumps (Manual) 500 cc　EA993KL-1A

With the oil level gauge on the top of the tank and the pump on the ground, you can check the amount of oil.

EAGLE (Konno Corporation)

Hydraulic Jack and others

EAGLE (Konno Corporation)

Lifting Jack　LJ-150

Jacks up to 67.5 mm from a gap of only 9.5 mm.
Operation handles are rotary, so you can use them from any direction.

EAGLE (Konno Corporation)

［Discontinued］Feed bar Type Jack with nail F-100T L5t　F-100TL

The feed base is attached to the jack with claws, and the alignment of the top and bottom and front and back is made more efficient.
Slides smoothly within a range of 100 mm, enabling horizontal movement after lifting.

EAGLE (Konno Corporation)

［Discontinued］Roller slide Type Jack with nail FR-60TL nail capacity of 3 t　FR-60TL

The feed base is attached to the jack with claws, and the alignment of the top, bottom, front, back, left and right is improved.
Slides smoothly within a range of 100 mm, enabling horizontal movement after lifting.

EAGLE (Konno Corporation)

［Discontinued］Base lifting Jack nail load 3 t and others

EAGLE (Konno Corporation)

［Discontinued］Ultra Long Claw jack (with Attachment/2 ton)　EA993KF-11

Esco Original Products