Spec

• [Type List]
• Pressure range: 0~0.1 MPa abs.
• Indication method: absolute pressure
• Joint Shape: G 1/4
• [General Specifications]
• PA-840: Unless otherwise specified, ambient temperature Ta=25±5°C, drive voltage Vopr=24 V DC, and pressure range Pin=Pr.
• Rated pressure range: 0~0.1 MPa abs.
• Maximum pressure: 0.2 MPa abs.
• Fracture pressure: 0.3 MPa abs.
• shape (indicating method): absolute pressure
• Operating Temperature: Ambient Temperature: -20~80°C, Pressure Receiving Part: -20~100°C No Freezing
• Insulation Resistance: 100 MΩ or More (500 V DC Between the Charging Part and the Joint)
• Compensation temperature: 0~50°C
• Operating humidity: 35~85%RH Non-condensing
• Storage temperature: – 20~80°C
• Applicable medium: Gases and liquids that do not corrode SUS316L
• Gas and liquid (G2 joint) that do not corrode O-rings (fluororubber)
• Pressure port/fitting geometry: G 1/4
• Mass: Approx. 250g
• Protection Structure: IP67
• [Analog Output]
• Output voltage: 1~5 V
• 0 voltage: 1±0.05 V
• Span voltage: 4±0.1 V
• Linearity: ±0.5% FS
• Temperature characteristic: 0/span ±0.06% FS/deg. C
• Power supply voltage: 10.8~26.4 V DC (including ripple)
• Current consumption: 20 mA or less
• [Environmental Characteristics]
• Item: Test method
• Standard
• Vibration: 10~500 Hz 1.5 mm or less/98.1 m/s2
• 3 directions 2 hours each
• The change in analog power (Vzero, Vspan) after the test shall be ±2%FS. Note 1
• Impact: 490 m/s2 3 times each in 3 directions
• Ibid., Note 1
• Pressure cycle: 0 to Pr 10^6 times
• Ibid., Note 1
• Moisture Resistance: 40°C 90~95%RH 240 hours
• Ibid., Note 1
• Note 1. The change in analog output (Vzero, Vspan) after the test shall be ±2%FS.
• [In Use]
• Do not insert a foreign object such as a wire into the joint as it will damage the diaphragm inside.
• Tighten the cable wiring port firmly with the attached cable gland, and take measures to prevent water from entering.
• Depending on the operating environment, the cable gland or the cover of the main body may become loose, and the waterproof property may be lowered. Therefore, prevent the cable gland from becoming loose or tighten the cover periodically.
• Since this product introduces atmospheric pressure through a cable, it is recommended to use a cable with a built-in atmospheric pressure introduction tube.
• Wiring should be done with the power OFF. Please note that short-circuiting between terminals may damage the internal circuit. Also, be careful not to miswire.
•