64-3180-83 Angle Protractor with General Calibration AP-130
Features
- Direct measurement can be performed without interfering with bulging after pressure welding or with the plating after welding.
- The angle measurement of the member before and after welding can be widely performed.
- The surface has an anti-gloss silver finish to make it easier to read the scale.
- Can also measure the angle inside and outside of sheet metal folding etc.
- Robust, Easy and Portable (with Plastic Case)
- Specialized for Angle Measurement! Three measurement points can be used to measure all angles.
Spec
- material : Stainless Steel (SUS410)
- Bending angle of butt joints and pressure welded parts: 0 to 90 °
- Groove (Bevel) Angle: Scissors Angle 30 to 130 ° (Minimum reading: 1 °)
- Tilt of Connection after Angle Stud Welding: 0 to 180 °, Angle Measurement Precision: ± 0.5 °
- Bending angle of pressure welded part, butt joint, bending angle of flange and sheet metal, angle measurement of welded joint, angle measurement of plate material scissors
- Body Mass: 100 g
- Body Total length: 105 mm
- Body full width: 90 mm
- Document Content: calibration certificate Traceability Chart
- Calibration points are the calibration points specified by the manufacturer. If you specify calibration points separately, you need to make a separate estimate.
| Order No. | 64-3180-83 | |
|---|---|---|
| Model No. | AP-130 | |
| Standard price |
JPY: 24,700
USD: 154.94
Excange rate 1USD= 159.42JPY
Valid price in Japan |
|
| Quantity | 1piece | |
| Stock in Japan |
|
|
| Supplier Stock |
|
|