64-3180-82 Angle Groove Gauge with General Calibration WGA-65
Features
- Sharpening of the tip allows measurement of thin plates with a route gap of 0 mm and 15 mm or less.
- Direct measurement of the groove angle of a welded joint is possible with this one.
- In addition, it is possible to measure the angle of the T-joint without overlaying.
- A large scale that is easy to use in the field. The minimum scale corresponds to 0.5°.
- The surface has an anti-gloss silver finish to make it easier to read the scale.
- Robust, Easy and Portable (with Plastic Case)
- Specialized for Angle Measurement! It is possible to measure the opening angle with the precision of the minimum reading value of 0.5° corresponding to various standard tolerances.
Spec
- material : Stainless Steel (SUS410)
- Groove (Bevel) Angle: 25 to 65 ° (Minimum reading: 0.5 °)
- Tilt of connection after stud welding: 70 to 110 °
- Angle measurement accuracy: ± 0.5 °
- groove angle measurement of butt joint, angle measurement of welded joint
- Body Mass: 74 g
- Body Total length: 117.5 mm
- Document Content: calibration certificate Traceability Chart
- Calibration points are the calibration points specified by the manufacturer. If you specify calibration points separately, you need to make a separate estimate.
| Order No. | 64-3180-82 | |
|---|---|---|
| Model No. | WGA-65 | |
| Standard price |
JPY: 24,700
USD: 153.68
Excange rate 1USD= 160.72JPY
Valid price in Japan |
|
| Quantity | 1piece | |
| Stock in Japan |
|
|
| Supplier Stock |
|
|