SMD Ferrite Beads (also known as Multilayer Chip Beads or Impeders) Sleeve Choke, 6 Hole Beads/Can be used in place of UHF Interference Suppression Choke Special multilayer design allows very small DC loss resistance values in decoupling applications such as power supplies The material used allows high loss resistance values to interference signals with EMC interference suppression in the frequency range greater than 100 MHz The ferrite beads act as absorbers but do not require grounding for filter function Required signal suppression is minimal On the substrate of an interference source or potentially interfering equipment, Effective EMC protection can be directly achievedMagnetic shielding design prevents perturbed radiation interferenceHigh packing densityExcellent solder propertiesBest for Ni-Sn electrodesBest for reflow/wave soldering and bondingWide impedance profileHigh current SMD ferrite filter for wide band decoupling of power cables (up to 6 A current) Material grade: 3 W110
Application: Decoupling filter circuits for EMC interference suppression power supplies for oscillators, buses, measurements, and data lines
Spec
Quantity:1bag(10pieces)
Package Type:1812 (4532M)
Impedance at 100 MHz:600Ω
Current Rating:3A
Dimensions:4.5 x 3.2 x 1.5mm
Length:4.5mm
Depth:3.2mm
Height:1.5mm
Maximum DC Resistance:40mΩ
CODE No.:358-6579
Order No.
64-1946-38
Model No.
742792514
Standard priceStandard pricess="init">
64-1946-38 Wurth Elektronik Ferrite Bead, 4.5 x 3.2 x 1.5mm (1812 (4532M)), 600Ω impedance at 100 MHz 742792514 【AXEL GLOBAL】<!--@[ss-27]@--> アズワン<!--@/[ss-27]@-->
SMD Ferrite Beads (also known as Multilayer Chip Beads or Impeders) Sleeve Choke, 6 Hole Beads/Can be used in place of UHF Interference Suppression Choke Special multilayer design allows very small DC loss resistance values in decoupling applications such as power supplies The material used allows high loss resistance values to interference signals with EMC interference suppression in the frequency range greater than 100 MHz The ferrite beads act as absorbers but do not require grounding for filter function Required signal suppression is minimal On the substrate of an interference source or potentially interfering equipment, Effective EMC protection can be directly achievedMagnetic shielding design prevents perturbed radiation interferenceHigh packing densityExcellent solder propertiesBest for Ni-Sn electrodesBest for reflow/wave soldering and bondingWide impedance profileHigh current SMD ferrite filter for wide band decoupling of power cables (up to 6 A current) Material grade: 3 W110
Application: Decoupling filter circuits for EMC interference suppression power supplies for oscillators, buses, measurements, and data lines
