SANWA SUPPLY INC.

64-0873-39　Blue Light Screen Protector (up to 10.1 inch)　LCD-101WBCF

Features

Supports up to 10.1 models.
Free cut type blue light cut liquid crystal protection fingerprint protection gloss film which can be cut to any size.
You can cut it to your desired size and attach it.
At the blue light main wavelength of 450 nm of the LED back monitor, about 26% cut.
The blue light, which is difficult to absorb by the lens of the eye and can damage the retina, is cut in concentration. Recommended for eye strain.
It reduces blue light and absorbs inside and outside of the film, making it easy on the eyes.
Fingerprint prevention prevents fingerprints from sticking to the film.
Since the adhesive surface is made of silicone material, it sticks perfectly to the LCD screen.
Double-sided tape is not required.
Ideal for Windows8 touch. Touch panel compatible.
Protects the LCD screen from dust, fingerprints, scratches, etc.

Spec

material: Adhesive Surface/Silicon Film, Outer Surface/PET
Size: W 190 x D 0.2 x H 270 mm
Quantity: 1 piece
Reflectivity: 5%
Transmittance: 81%
ultraviolet ray cut : 99.9%
Surface Hardness: 2 to 3H
*The film is a blue-light cut, anti-fingerprint gloss type.
*The above are measured values, not guaranteed values. [Protection film cutting method] (1) Measure the size of the equipment to be attached using the grid paper on the back of the package. ② Use the grid paper to decide the size to cut out from 4 marks.
*If you have a tablet or other device that is flat to the frame, make it a little larger (2 to 3 mm) so that it covers the entire LCD.
*If you have a model with a step between the LCD screen and the frame, please make it a little smaller (2 to 3 mm). This is because it is difficult to align the right and left sides of the upper and lower if the size is perfect. ③ Place the film main body on top of the grid paper and cut it off. (You can cut it with scissors, but I recommend to cut it neatly with a cutter knife.) [Protection film sticking method] (1) Clean the LCD screen and main unit. (If dust gets caught, it may cause air bubbles.) ② Peel off the glue sheet before applying the film. The removed side is the side that can be attached to the LCD screen. When removing the nail polish remover, work in a place with as little dust as possible to prevent dust from static electricity. ③ Apply the protective film slowly from the edge. It will be easier to stick if you push out the air with a soft cloth.
*Please be careful not to press the LCD screen too hard when attaching, as it may cause damage.
*Be careful not to get injured when cutting the product with scissors or a cutter knife.
*Sanwa Supply assumes no responsibility for any accident or damage caused by the disconnection of this product.
*When the product is applied to the entire surface of a flat device such as a tablet, the R (bend) of the corner cannot be measured. Protect the chisel of the LCD.
*Cutting the film may place a load on the edge of the film, causing part of the film to float. Thank you for your understanding.

Package size：208×3×303 mm　60 g　 [About Package size]

Order No.	64-0873-39
Model No.	LCD-101WBCF
JAN Code	4969887869659
Standard price	JPY: 2,980 USD: 18.54 Excange rate 1USD= 160.72JPY Valid price in Japan
Quantity	1piece
Stock in Japan
Supplier Stock