Ideal for machining from carbon steel to hardened steel (~55HRC) using water soluble, oily cutting oil.
High-quality, high-performance, low-cost end mill.
Applicable Work Materials: Carbon Steel, Alloy Steel, Pre-Hardened Steel, Quenched Steel (~55HRC), Cast Iron, Copper (Wet), Titanium Alloy (Oil-Based Cutting Oil), Super Heat-Resistant Alloy (Oil-Based Cutting Oil) * * Shank Taper Angle is a guide.
* If you are concerned about the interference with the work, be sure to observe the actual measurement. Be careful of contact between the shank and the workpiece.
Spec
Number of entries: 1
Ball Radius (R): R 1.75
Blade length (l): 8
Shank Taper Angle (Bta): 16 degrees
Total length (L): 70
Shank diameter (phi d): 6
UT Coating
Helix angle 30 degrees
Manufactured at factories with ISO 14001 certification
Material/Finish: Ultrafine Grain Alloy (Super MG)
Securities Code: 340 -6431
Order No.
62-3356-03
Model No.Model No. class="init">
［Discontinued］Carbide End Mill, Ball R 1.75 x Blade Length 8 CCEB2035 62-3356-03 【AXEL GLOBAL】<!--@[ss-27]@--> アズワン<!--@/[ss-27]@-->
Ideal for machining from carbon steel to hardened steel (~55HRC) using water soluble, oily cutting oil.
High-quality, high-performance, low-cost end mill.
Applicable Work Materials: Carbon Steel, Alloy Steel, Pre-Hardened Steel, Quenched Steel (~55HRC), Cast Iron, Copper (Wet), Titanium Alloy (Oil-Based Cutting Oil), Super Heat-Resistant Alloy (Oil-Based Cutting Oil) * * Shank Taper Angle is a guide.
* If you are concerned about the interference with the work, be sure to observe the actual measurement. Be careful of contact between the shank and the workpiece.
仕様
Number of entries: 1
Ball Radius (R): R 1.75
Blade length (l): 8
Shank Taper Angle (Bta): 16 degrees
Total length (L): 70
Shank diameter (phi d): 6
UT Coating
Helix angle 30 degrees
Manufactured at factories with ISO 14001 certification
