ELECOM CO., LTD

62-2050-36　［Discontinued］Business Wireless AP 300 Mbps 11 a.n.g.b PoE Switched Communication Type　WAB-S300

Products Information

Features

Compatible with 11n/a and 11n/g/b popular standards, 300Mbps switching at 5 GHz. 4 GHz. Can be used for office environments. It is the best entry model for the first wireless introduction. The system will support WAB-MAT, a dedicated software that can be installed regardless of the power supply environment by using the PoE power receiving function and can be managed in a single operation such as changing settings and checking operation status. *The radio speed is compatible with the standard maximum of 11n/a and 11n/g/b. Compatible with switching communication of up to 300Mbps (standard theoretical value) at 5 GHz and 2.4 GHz respectively, and can be used according to the office environment. This is the best entry model for wireless installation in offices for the first time.
Connecting to 11n/a-compatible wireless LAN subunits enables high throughput at 5 GHz with minimal interference and greatly improves operational efficiency.
Supports PoE power reception. With PoE, even if there is no power supply nearby, you can use only a LAN cable to power the network efficiently. Network expansion is also easier with the remaining LAN ports.
Equipped with guest network functions, you can separate the visitor network from the internal network while protecting security.
Multiple SSIDs can be managed by a single wireless access point, enabling you to configure authentication and encryption methods for each SSID to enable a variety of security policies on a single device. (Up to 5 SSIDs)
You can configure a secure network that supports IEEE802.1x/EAP authentication, which allows only authorized users to connect to the network. This can be combined with a Radius (authentication) server to prevent unauthorized devices from connecting.
Support for WAB-MAT, a dedicated management software that enables users to change the settings of wireless access points and check the operating status of wireless access points in a single operation. This will contribute to a significant reduction in man-hours of management.
Equipped with a power-saving schedule function that automatically turns off the radio and LEDs at offices on holidays when the frequency of wireless LAN use is low. Energy-saving without any hassle.
Special metal fittings are attached as standard. Suitable for various mounting methods such as wall mounting and ceiling mounting.
With built-in antenna, antenna does not get in the way during wall installation. It also supports Kensington lock to protect your equipment from theft.
Equipped with a unified disaster SSID "00000 JAPAN" that allows everyone to communicate smoothly even in a large-scale disaster. To provide a quick communication environment to your smartphone, tablet or PC in case of emergency.
High quality and heat resistant to 50°C for long term use. Suitable for use in various environments.
A long-term 3-year warranty that gives you peace of mind for corporate use. We also offer optional extension and delivery maintenance.

Spec

Wireless LAN Partition-Compliant standards (standards International): IEEE 802.11 n/g/b, IEEE 802.11 n/a (W 52/W 53/W 56)
Wireless LAN Department Compliant standards (Domestic standards): ARIB STD-T 66, ARIB STD-T 71
Wireless LAN part frequency range (center frequency): 2.4 GHz: 2,400 to 2,484 MHz, 5 GHz: 5,150 to 5,725 MHz
Wireless LAN section channels: 2.4 GHz band: 1 to 13 ch, 5 GHz band: 36, 40, 44, 48, 52, 56, 60, 64,100,104,108,112,116,120,124,128,132,136,140 ch
Wireless LAN part modulation/demodulation method: IEEE 802.11 n: MIMO-OFDM, IEEE 802.11 a/g: OFDM, IEEE 802.11 b: DS-SS
Wireless LAN part communication type: 2.4 GHz/5 GHz switching communication
Wireless LAN Antenna: Internal Antenna 2 pieces (2.4 GHz/5 GHz band Send/Receive 2 pieces)
Wireless LAN part data communication speed (specification value): IEEE 802.11 n: maximum 300 Mbps, IEEE 802.11 a/g: maximum 54 Mbps, IEEE 802.11 b: maximum 11 Mbs
Antenna power of wireless LAN section: 10 mW/MHz or less
Wireless LAN connections: up to 25
Wireless LAN Part Authentication Methods: Open System Authentication, Shared Key Authentication, IEEE 802.1 x/EAP (EAP-TLS, EAP-TTLS, EAP-PEAP), WPA/WAP2 (Personal, Enterprise)
Wireless LAN encryption method: WEP: 64/128 bit, WPA/WPA2: AES, TKIP
MAC address filtering in the wireless LAN section: 256
Wireless LAN Section and Other Security Functions: Rogue AP Detection, SSID Concealment, SSID Separator, STA Separator
Wireless LAN part and other support functions: radio wave output adjustment, WDS (Max 4 pieces), guest network, WPS, load balance (connection limit), disaster mode "00000 JAPAN"
Wired LAN standards: IEEE 802.3 10 BASE-T, IEEE 802.3 u 100 BASE-TX, IEEE 802.3 ab 1000 BASE-T, IEEE 802.3 az Energy Efficient Ethernet, IEEE 802.3 x Flow Control, IEEE 802.3 at/IEEE 802.3 af Power over Ethernet, IEEE 802.1 Q VLAN Tagging
Wired LAN part data communication speed (specification value): 10 Mbps/100 Mbps/1000 Mbps
Wired LAN part ports: 10/100/1000 BASE-T (RJ- 45 type 8-pole connector) x 2 * 1 port is a PoE powered port (PD (IN)), 1 port is a LAN port, auto-negotiation/Auto MDI/MDI-X capable
features supported multiSSID: maximum 5 pieces
Feature Tag VLAN (IEE 802.1 Q): Max 5 pieces, VID = 1 to 4,096
supported features QoS: WMM capable
Manageability Management Protocol: SNMP v1/v2c/v3
Management features and more: Web UI, logging, planned WAB-MAT support, backup and restore configuration files, firmware updates, Syslog and Syslog forwarding, NTP client, Power saving schedule
Clients supported (when wireless is connected): WindowsVista/7/8/8.1/10 (32 bit/64 bit) MacOS X 10.7/10.8/10.9/10.10/10.11 Android 4.0 or later iOS 5.0 or later
Supported browsers (WebUI Configuration Time): Internet Explorer 8 or later Chrome version 23.0 or later Firefox version 17 or later Safari version 5 or later.
standards EMI standards: VCCI Class B
standards Safety standards Compliant : IEC 61000 -4
Technical standards based on the standards Radio Law: TELEC
standards Interconnect Authentication: Wi-Fi
standards environmental standards: RoHS
LED PWR: power supply ON
LED STATUS lights during product start-up or when an error occurs.
LED LINK PD/IN: ON while connected to LAN
LED LINK PSE/OUT (LAN): ON while connected to LAN
LED 2.4 GHz: On when using 2.4 GHz wireless LAN
LED 5 GHz: On when using a 5 GHz wireless LAN
LED: Lit when USB memory is connected
LED PWR/PD: On when PoE is received
PoE Feeding Devices Supported: IEEE 802.3 at/af Feeding Devices
With power supply PoE: rating input voltage IEEE 802.3 af 37 V -57 V/IEEE 802.3 at 42.5 V -57 V, Power Consumption 7.7 W, calorific value 27.7 kJ/h
When using the power supply AC adapter: rating input Voltage AC100 to 240 V, rating Frequency 50/60 Hz, Power Consumption 7.7 W, calorific value 27.7 kJ/h
Operating Temperature: 0 to 50 ° C
Operating Humidity: 10 to 90% (No condensation)
Environment Condition Storage Temperature: -20 to 60 ° C
Humidity at ambient storage: 95% or less (No condensation)
external dimensions : Width 178 mm x Depth 183 mm x Height 40 mm
Mass: about 450 g (main body only)
Package Contents: 1 Unit, Wall Mount Plate 1 piece (Wood Screw 4 pieces), Manual 2 pieces (Quick Setup Guide for Safe Use), Serial Seal 2 pieces
Optional: WAB-Series AC Adapter: WAB-EX-AC 12, Management Software: WAB-MAT (Plan to respond)
Warranty: 3 years
Compliance with EU RoHS Directive

Package size：217×240×74 mm　950 g　 [About Package size]

Order No.	62-2050-36
Model No.	WAB-S300
JAN Code	4953103478916
Standard price	JPY: 14,800 USD: 92.77 Excange rate 1USD= 159.53JPY Valid price in Japan
Quantity	1piece

Stock in Japan	-