Spec

• Helix Angle (°): 0
• Machining Hole Depth (L)/Machining Diameter (D) ≤ 5
• Processing Diameter (φDc); mm ) : 30 to 32
• Dimensions φDs ( mm ) : 32
• Dimensions φD2 ( mm ) : 40.0
• Total length (L; mm ) : 248
• Dimensions L2 ( mm ) : 150
• Dimensions ls ( mm ) : 60
• Usable Insert: WPMT040208-D3
• Pilot Drill: DP08 (φ8)
• Parts Used: Cartridge Peripheral Blade (CW04A)/Inner Blade (CW04B)/Tightening screw Insert (CSTB -2.5 S)/Cartridge (BHM4 -8)/Pilot Drill (SSHM5 -10)/Oil Hole Plug screw (PT 1/4 GN)/Spanner Insert (T -8 D)/Cartridge (P -2.5)/Pilot Drill (P -2.5)/Oil Hole Plug screw (P -6)/Shim Sheet Set (SW04)
• *Diameter can be adjusted by the shim sheet set (0.5 mm steps in diameter with a maximum of 2 to 5 mm).
• *Pilot drill is built into the body, but insert is not. Please order separately.
• *When cutting steel, be sure to use water-soluble cutting oil. In addition, 10 R/min of oil and 1 MPa of oil pressure are required.
• *When using for tool rotation, use a commercially available rotary lubrication holder.
• *Drilling with overlapping workpiece materials is not recommended as it may damage the tool.
• *Not recommended for machining of low carbon steel (SS 400) or stainless steel (SUS304).
• *Machining diameter φDc is the tool diameter adjustment range.
• Pilot drill is an accessory.
•